This for the 1610 but use the URL then search for yours, be sure to turn off you printer as well. If they were working properly, then the problem might be a piece of software you installed after the printer that is causing a conflict. So, I usually make sure on a new install that my printer, scanner, webcam etc and any other hardware attached to the computer is functioning properly before I install and software. There are conflicts with one piece of software relitive to another. There are problems that are relative to each individual computer and the software they have on that computer. Remember this is a BETA version and not everything will work for everyone. Worst case scenerio is you stay with XP and wait for RTM in January. (When you upgrade you are also upgrading any problems you might have had before) If you did not I would suggest you do a new clean install of RC1 not an upgrade. If the printer works in XP then you do not have a printer problem. If none of the above works, I suggest you revert back to XP. If that does not work, try reinstalling it the old fashion way of unplugging the printer from the computer and put the installation DVD into the CD/DVD Rom and follow the install instructions. (First uninstal the printer using Control Panel/uninstall a program - look for you printer here and uninstall it) Restart the computer then reconnect the printer to the computer and it should be detected. However, Vista's plug and play should detect it, if you unplug the printer from the computer and plug it back in. The printer was detected and is working without any problem. I'm using RC2 and my HO 6210xi was connected when the OS was installed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |